Wednesday, November 20, 2019
Home » News » RPM Front & Rear Skid Plates for Losi Tenacity

RPM Front & Rear Skid Plates for Losi Tenacity

Does your Losi Tenacity Short Course Truck, Truggy or Desert Buggy need some extra chassis protection? Well, RPM has a great solution with their front & rear skid plates for Losi Tenacity which are designed to fit both the molded chassis version of the Tenacity as well as the aluminum chassis option.

RPM Front & Rear Skid Plates for Losi Tenacity

Molded Chassis versions of the Tenacity

A key breakage area of the molded Tenacity chassis reported to RPM engineers is the area located just behind the front bulkhead mounting screws. By tying together the four bulkhead mounting screws with the two screws holding the steering mounting posts in place, RPM was able to beef up the strength and durability of the entire front end of the chassis, helping to reduce that pesky breakage problem while adding some much needed abrasion resistance to the chassis.

Aluminum Chassis versions of the Tenacity

MSRP on a new aluminum chassis for the Tenacity is $55.99. Ouch! It only makes sense to protect that chassis for as long as possible. What better way is there than a product specifically designed to reduce skid and abrasion resistance? RPM’s skid plates will not only increase the longevity of your valuable aluminum chassis, they’ll also significantly reduce the amount of scuffs and scratches it’ll receive since these skid plates are the lowest impact point on the chassis

Both chassis versions

Out back, the RPM rear skid plate adds some much needed abrasion and wear protection. Whether you’re running a molded chassis or an aluminum version, no one wants to replace a chassis because it wore out. It’s much easier and less expensive to replace a skid / wear plate such as the ones from RPM. You’ll also encounter less build-up of dirt and debris between the chassis and the lower rear bumper mount since the RPM rear skid plate sits lower than the bumper mount.

RPM skid plates are made in the USA from RPM’s incredibly tough blend of engineering grade nylons for performance you can count on. Get yours today!

Tech Notes: RPM skid plates fit #LOS231023 molded chassis versions and #LOS231056 aluminum chassis versions of the Tenacity (SCT, T & DB. Not for use on MT versions).

For more information, visit: RPM

Leave a Reply

Your email address will not be published. Required fields are marked *