Thursday, February 29, 2024

RPM Front A-arms for Arrma Kraton, Outcast, Notorious, Fireteam And Talion

RPM Front A-arms for V5 / EXB editions of the Arrma Kraton, Notorious, Talion, Fireteam & Outcast are an all new design. The design modifications accommodate changes made by Arrma for V5 and EXB versions of these vehicles, although they are reverse compatible for older models (see “Version Notes”).

RPM Front A-arms for Arrma Kraton, Outcast, Notorious, Fireteam And Talion

These A-arms are significantly beefier than RPM’s original 6S version A-arms. Lower A-arm support beams are 30-percent thicker while upper A-arms are more than 22-percent thicker. The added thickness not only improves durability and strength, it also reduces flex. Less flex equates to more predictable suspension performance and handling.

On the lower A-arm, RPM added a second shock mount hole further outboard. This additional position provides a lower profile suspension set-up. The shocks lay down a little further, dropping the ride height for a lower center of gravity. A lower center of gravity equates to higher corner speeds.

As for the upper A-arm, RPM eliminated the caster spacers. This gave them room to widen the arm at the inner hinge pin mount. The extra width creates more of an “A” shape, stabilizing the upper A-arm. A more stable A-arm improves steering and suspension performance while adding strength and durability.

All RPM A-arms are molded from their nearly indestructible blend of engineering grade nylons for performance you can rely on when the conditions are at their worst.

Tech Notes: RPM Arrma Kraton, Talion, Notorious, Fireteam & Outcast A-arms are sold as one upper and one lower in each package. One left and one right package is needed for each vehicle. RPM A-arms replace the upper arms from Arrma #330655 and the lower arms from Arrma #330656.

Version Notes:
V5 & EXB models: Stock replacement A-arms for Arrma #330655 and Arrma #330656.
V4 and earlier models: Requires 1 – Arrma #ARA713032 Shock Mount Pin & 1 – Arrma #ARA330645 End Cap. Replaces stock Arrma #AR330218 & #AR330219.

For more information, visit: RPM

Leave a Reply