fbpx
Monday, June 27, 2022
New From Traxxas 2022

RPM Rear A-arms for Arrma Kraton, Outcast, Notorious, Fireteam and Talion

Following last month’s RPM release of the front suspension arms for Arrma vehicles, are the RPM Rear A-arms for Arrma Kraton, Outcast, Notorious, Fireteam and Talion vehicles.

RPM Rear A-arms for Arrma Kraton, Outcast, Notorious, Fireteam and Talion

These RPM rear A-arms are for V5 / EXB editions of the ARRMA Kraton, Notorious, Talion, Fireteam and Outcast and are an all new design. The design modifications accommodate changes made by ARRMA for V5 and EXB versions of these vehicles, although they are reverse compatible for older models (see “Version Notes” below).

RPM Rear A-arms for Arrma Kraton, Outcast, Notorious, Fireteam and TalionThese RPM A-arms are significantly beefier than their original 6S version A-arms. Support beams are 30-percent thicker, improving durability and strength while reducing flex. Less flex equates to more predictable suspension performance and handling. RPM also added a second shock mount hole further outboard. This additional position provides a lower profile suspension set-up. The shocks lay down a little further, dropping the ride height for a lower center of gravity. A lower center of gravity equates to higher corner speeds.

These A-arms are molded from RPM’s nearly indestructible blend of engineering grade nylons for performance you can rely on when the conditions are at their worst.

RPM Rear A-arms for Arrma Kraton, Outcast, Notorious, Fireteam and Talion

Tech Notes: RPM ARRMA Kraton, Talion, Notorious, Fireteam and Outcast A-arms are sold as a pair (1 – left & 1 – right) in each package. These RPM A-arms replace ARRMA #ARA330654.

Version Notes:
V5 and EXB models: Stock replacement A-arms for ARRMA #ARA330654. Inner shock mount and inner sway bar holes are stock geometry. Do not use outer shock mount and outer sway bar holes for V5 / EXB models.
V4 and earlier models: Stock replacement A-arms for ARRMA #AR330249. Outer shock mount and outer sway bar holes are stock geometry. Do not use inner shock mount and inner sway bar holes for V4 or older models unless converting to V5 / EXB suspension components.

For more information, visit: RPM

Leave a Reply

Your email address will not be published.